HUGO User Manual

HUGO-X1 User Manual
www.safeguardpowersolutions.com 855.484.6797 P a g e | 3
WARNING
Use personal protective equipment. Safety glasses must be worn at all times by
all persons installing the UPS.
Have your UPS serviced by a qualified repair person using only identical
replacement part.
ELECTRICAL SAFETY PRACTICES
WARNING
ONLY OPERATE THE UPS INA CLEAN ENVIRONMENT.
DO NOT EXPOSE THE UPS INTERIOR TO RAIN OR WET CONDITIONS.
WATER ENTERING A UPS WILL INCREASE THE RISK OF ELECTRIC SHOCK.
KEEP AWAY FROM LIVE CIRCUITS
• Operating personnel must not remove covers.
• Replacement of components and internal adjustments must be made by qualified
maintenance personnel.
• Disconnect power when replacing components.
• Dangerous voltages may exist even with the power removed.
• To avoid injuries, always disconnect power and tum power switch to OFF.
• Input connection to the product must remain accessible as a disconnect device.
• DO NOT work on the product; connect or disconnect cables during periods of lightning.
• Provide wiring per national and local electrical codes.
BATTERY WARNING
• Turn off the UPS and unplug it from the AC power source before battery replacement.
• This UPS contains a sealed lead-acid battery. DO NOT open the battery
• DO NOT short or bridge the battery terminals with any object.
• The battery must be charged within 80 days from receiving the UPS. It is strongly recommended to cycle
the charge within the battery every 90-120 days for battery to maintain its optimum performance.
• Ensure to charge the battery fully with each charge. Battery damage may occur if these instructions are
not followed.
• Before replacing battery, make sure the replacement battery has the same charging voltage (12V/35 Amp
Hours.) If any doubt, contact the manufacturer.