HUGO User Manual

HUGO-X1 User Manual
www.safeguardpowersolutions.com 855.484.6797 P a g e | 11
d) Make sure not to tangle the wires inside the HUGO unit for easier maintenance and service calls
in the future.
e) Connect your appliance’s wire cords G (green), N (white), and L (red or black) to the
corresponding positions on HUGO’s “AC Output” of the green plug.
 G to PE
 N to N
 L to L
f) Ensure no bare wires are exposed to the outside.
g) Tighten the flat head screws on the green connector.
h) Pull the newly installed wires to ensure a tight connection.
i) Plug the green connector back to the inverter.
9. STORAGE AND TRANSPORTATION
Retain the packing box and packing materials. The HUGO-X1 is a sensitive piece of power
equipment. When storing or transporting, place the unit back into the original packing box to
avoid any damage from moisture, dust, dirt or chemical corrosion.
10. MAINTENANCE AND TROUBLESHOOTING
a) Maintenance
• Upon successful installation of the unit, user shall visit the manufacture’s website
(www.safeguardpowersolutions.com) to register the UPS under “Product
Registration”. Once registered, the UPS’s serial number will activate its warranty
starting date.
• If the unit has not been activated by any power outage for a long period of time, it is
recommended to unplug the HUGO-X1 from the main power source to allow the unit
to operate on battery mode until battery depletes. Once battery depletes, plug the
unit back to main power source to allow battery recharge. This maintenance shall
be done every 6 months for the battery to maintain its optimum performance.
• It is recommended to periodically unplug the UPS from the main power source to
check the UPS’s normal operation. If any fault is detected, read the LED indicator