HUGO User Manual

HUGO-X1 User Manual
www.safeguardpowersolutions.com 855.484.6797 P a g e | 10
leakage.
8. HARDWIRING INSTRUCTION
If your appliance does not have a plug and requires hardwiring, it is strong recommended that the
following procedures to be completed by a certified electrician and the installer must follow all
codes to ensure the safety of installation and operation. Improper install voids the warranty for the
HUGO product. Upon completion, please send a photo of the completed install to support@sps-
us.net to ensure warranty will still be intact.
a) Loosen the three wiring screws on the “AC Output” green plug as shown in photo below:
b) Remove the three wires from factory:
 Green-yellow (Output Ground, or “PE”)
 Blue (Output Neutral, or “N”)
 Green (Output Hot, or “L”)
c) Feed your appliance’s cord from the outside of HUGO’s wiring box to get inside the HUGO unit,
as shown below: