Owner's Manual

TEIAL SRT
If you encounter any difficulty in the operation of this product after
reading the manual, please contact us. You can reach us by phone at
 from  A to   onday through riday astern
tandard Time. e will be happy to answer your uestions and help you
in any way we can.
ARRATY
agarwarransisrocorocsinariaan
woransiorario oonarro  aorcas.is
warran os no covr aag rsing roaccinasacoo
orirororaion.isrocos co civsi rrn i
o agar. Pasincanoscriingrosaongwi
ornaanrrnarssaswasoriginasasrci.
rocis covr nr warran i wi  rairor rac a no
carg.iisnocovrwarranowinoiioancargs
orworison.
Saeguar Suly
 oon tation t.  
ennesaw, A 
www.safeguardsupply.com
Test the rograing
After completing the programming steps aboe, test the
programmingpairing prior to mounting the transmitter. ush the
"front door" button andor the "back door" button on the transmitter.
You should see a red  on the transmitter  the receier should flash
andor play the selected melody see receiers for mode of operation
settings. If theres no red  on the transmitter, ensure the plastic
wrapper is remoed from the battery  its inserted correctly.
Installing/Mounting the LRA-EXTX to Your Doorbell
The transmitter may be small enough to fit inside your wired doorbell
cabinet or you may decide to simply set it on top of your wired door
chime cabinet. The instructions below illustrate using the "cable duct."
This is not mandatory and is only aesthetic purposes. After wiring the
transmitter to your wired doorbell, you can decide the best location to
place the transmitter. You can use the double sided tape or mounting
screws to mount the transmitter to the wall, hide it in the doorbell
cabinet, fix to the side, or simply lay it on top of the doorbell cabinet.
We recommend using the included screws to enable you to easily take
it down to change the batteries.
Insert the cable duct to the base
lace the wires in the cable duct and
replace the cable duct coer
aWire
(Transformer)
Red Wire
(Front Door)
White Wire
(Back Door)
+
+
+
iring the Transitter to Your ire Doorbell
oarnoaiiarwicricarocsasira
criicrician.nsroavnoowrgoingoor
wiroorrningocircirar.
• onnect the red wire from the transmitter to the front door
terminal screw on your wired doorbell see  aboe.
• onnect the black wire from the transmitter to the second
or back door terminal screw on your wired doorbell. If you
are not using a second door you can go ahead and connect
it or wrap the connector of the wire in electrical tape to
preent interference.
• onnect the black wire from the transmitter to the
"transformer," or "common" terminal screw on your wired
doorbell.
• Test the installation by pressing the outdoor push button.
nsure you hae turned the power back on and the
receier is turned on.
• Your wired doorbell should ding as normal  your A
receier should respond per its settings.
• lace the transmitter in the desired location  affix it using
the doublesided tape or mounting screws.
Lo attery Iniator
A randomly blinking one light on the A receier or a red
 in the A indicates that the battery is low for this
transmitter. receier. lease replace the battery as soon as possible.
If the strobe light on the A seems to randomly flash, it means
the batteries in the receier are weak and needs to be replaced.
ARI ancer and eproductie arm. o to www.P65Warnings.ca.gov for more information.