User`s guide

AIRSHIP © 2009
Page 55
Sensor/Relay
The Sensor/Relay configuration allows you to configure and name the Sensors and Relays
that are attached to the Server. An I/O Alarm Controller (purchased separately) is required
for connecting alarm sensors and relays. A RS-232 to RS-485 converter may be needed to
connect the alarm controller to the PC‟s serial port (RS-232). The system can be configured
to respond to sensor inputs in a variety of ways as described in the Sensor and Cameras |
Alarms sections.
COM Port: Set which COM Port the Alarm Controller is plugged into via the RS-232/485
converter.
Address: Set the RS-485 address for the Alarm Controller.
Sensors: Set the number of Sensors on the Alarm Controller at the COM Port and
Address specified.
Relays: Set the number of Relays on the Alarm Controller at the COM Port and Address
specified.
Enable Device: Check this box to enable the I/O device configured.
Activate Relays: Check this box to activate all Relay actions as defined in Cameras |
Alarms.