User`s guide

AIRSHIP © 2009
Page 48
Presets & Tours
Presets
The Presets panel allows you to call PTZ Presets and Start and Stop the programmed
tour.
First, select the PTZ camera on the display screen so that it is highlighted in orange. Then,
use the number pad to select the Preset number to move the PTZ camera to. Finally, click
Go to Preset.
Click Start Tour to start the selected PTZ camera's programmed Tour.
Preset Programming: Preset Programming allows you to program a PTZ camera to react
to an Alarm, and program the PTZ camera to perform a series of movements called a
Tour. This system allows you to define a set of Presets, which are numbered positions
for the camera to point to. From there, you can program the PTZ camera to go to a
specified Preset in reaction to an Alarm or tour through the Presets in a certain order.
Steps to Program Presets
1. Position: Click on the PTZ camera display screen so that it is highlighted in
orange. From the main PTZ Panel, use the arrow keys to position to camera.
2. Click on PTZ Tab > PTZ Tools > Set Presets
3. Preset: Use the number pad to select the Preset Number to set.
4. Set Preset: Click Set to associate that position with the selected Preset
number.
5. Call Preset: If the Preset is already programmed, click Call to have the
camera move to that position now.
6. Delete: Deletes a Preset setting.
Steps to Program Tour
1. Confirm Presets: To check what presets are programmed for the camera, use
the number pad to select a preset number and click Call.
2. Add: Add the selected Preset to the Scan Preset Serial list. Set the Keep
Time to have the Camera stay at a certain location for a specified period of
time. Note that the Keep Time must include the time it takes the camera to