User`s guide

AIRSHIP © 2009
Page 36
1. Exit the Airship Server application.
2. Run the Server Setup Tool.
3. Go to IP Camera Setup and click the IP Setup button.
4. Click the Add + button to add a new IP Camera.
5. Enter all of the required information.
6. IP Address: The IP Address of the IP Camera. Should be the same you used to connect
to the IP Camera for initial configuration.
7. Port: Usually this is 80, however your IP Camera may be configured differently.
8. Name: Choose a useful name, such as Front Door or South Hallway.
9. Type: Choose your IP Camera type or manufacturer name. (If you do not see your IP
Camera maker's name here, contact Airship Support to request development on your
favorite IP Camera at [e-mail])
10. Enabled: This is an indication of whether or not the IP camera is able to be used by the
server or not. Once you have successfully retrieved the properties from the IP camera,
confirming that the IP address is valid and the user and password are correct, this value
changes from no to yes.
11. Click OK to save your settings. Highlight the IP camera from the list in the IP Setup Tool
and click Configure.
12. Enter the Username and Password.
13. Click Retrieve to conduct a test connection and retrieve camera information. If the
information below says Connected and fills in the firmware version and other
information, then we have conducted a successful test connection.
14. To troubleshoot any problems, use the Configure button to attempt to connect to the IP
Camera's web service. If you have trouble connecting, make sure that you can connect
to the IP Camera with the username and password you entered here by connecting to