User`s guide

AIRSHIP © 2009
Page 129
9. Once connected, click the Apply button to save your new Server configuration.
Server Setup
Enable: If unchecked, the server is disabled from use by the Client.
Server Type: Currently only the DVR/DVS type is allowed.
IP Address: Change the IP Address if needed.
Command Port: Change this port number if the Command Port on the Server is different
from the default, 6001.
Server Specific Login: If checked, you will connect to this Server with the user indicated
in Setup User, rather than the user you logged into the Client as.
Retrieve Server Properties: Click this button to initiate a connection to the Server. If the
Server Properties below get filled in with the Number of Cameras, etc, then you are
connected.
Configure Remote Server: Click this to open the Remote Server Setup window. You can
configure all Server options available in Server Setup, just like if you were at the Server
itself. See Server | Setup. NOTE: You must have the Setup permission for your user.
See Server | Setup | User Management.
Server Properties
Here you see the number of Cameras, Sensors, and Relays available on the connected
Server. You can also see the Port numbers that the Client will use to communicate with this
server. This information is useful to network administrators when troubleshooting a