Service manual

SiteStand Mobile Docking Station Service Manual 13
3.3.5 Replacing the SiteStand station Fuse
To replace the electrical fuse:
1. Disconnect the AC line cord from the hospital-grade electrical outlet.
2. Disconnect the AC line cord from the bottom of the SiteStand mobile docking
station.
3. Use a small, slotted screwdriver to remove the fuse drawer (located directly
below the input AC connector on the SiteStand mobile docking station).
CAUTION:
`
``
` You should identify the cause of the blown fuse prior to plugging the docking
station back into AC power.
4. Carefully replace the blown fuse with a 250 volt, 6.3 amp, 5.0 x 20 mm Slo-
Blo®-type fuse.
5. Install the fuse drawer.
6. Connect the AC power to the SiteStand mobile docking station.
AC power input
connector
Video output connector
Power output connectors
Printer and VCR
control connector
Fuse drawer
Audio output connector
Video output connector
RS-232C communication
connector