Service manual

SiteStand Mobile Docking Station Service Manual 11
3.3 Disassembling the SiteStand mobile
docking station
Disassembly of the SiteStand station is dependent on the repairs required. The
following order of disassembly is recommended in order to prevent damage to the
SiteStand station and facilitate efficient repairs. The service provider uses
professional judgement in altering this order to provide repairs to various parts of the
SiteStand station.
3.3.1 Required Materials and Equipment
• #1 Phillips screwdriver
• Allen wrench (5/32 inch and 1/8 inch)
• Slotted screwdriver
• Socket (11/16 inch or 17 mm)
3.3.2 Replacing the Sleeve Assembly and the Docking
PCBA
1. Tilt the sleeve assembly to its most upright position.
2. Use a #1 Philips screwdriver to remove the six screws from the metal base of the
sleeve assembly.
3. Turn the sleeve assembly over and remove the two philips screws holding the
cable connector to the sleeve assembly.
4. Unplug the connector and set the sleeve assembly aside.
5. Remove the five Phillips screws attaching the PCBA to the sleeve assembly.
6. To replace the sleeve assembly, follow steps 1 through 5 in reverse order.
3.3.3 Replacing the Foot Pedal
1. Using the 1/8 inch allen wrench remove the shoulder bolt holding the foot pedal
in place.
2. Remove the foot pedal.
3. Reinstall the foot pedal and insert the shoulder bolt.
4. Tighten the shoulder bolt so it is secure and the foot pedal moves freely.