User manual

P1 Audio Processor User Manual Page 9
 Adjust the preset output gain control (screwdriver
adjustment) until the desired recording level is shown on
your recording device metering; best to allow 1dB below
0dBFS.
MAIN OUTPUT
The balanced main output is fed via the preset level control
described above to a
3 pole balanced ¼” jack labelled ‘LINE OUT (BAL)’.
An LED bargraph shows the output level prior to the output gain
control.
THE MONITORING CHAIN
Stereo input designed to be fed from the replay chain of your
recording device. Can accept either a single 3 pole ¼” jack for
unbalanced stereo connection OR two 3 pole ¼” jacks for balanced
stereo connection. Plug as shown on the unit’s rear panel.
The monitoring chain feeds the front panel ¼” stereo jack socket best
connected to headphones with an impedance of 600 ohms or above.
It is safe to connect low impedance headphones but monitor audio
quality will degrade.
For track laying and overdubbing, it is also possible to mix in a feed
of the unit’s main processor path which has it’s own ‘source monitor’
level control. This level control does not affect the processor’s main
audio path level.