User manual

P1 Audio Processor User Manual Page 5
This unit must be earthed.
This unit should only be connected to a
mains supply of the type marked on the
rear of the appliance. Take special note of
the required mains voltage.
The IEC mains connecting lead originally
supplied with this unit has been fitted with a
3A mains fuse. Always replace with a fuse
of the same rating. (UK plugs only)
This unit is fitted with an externally
accessible fuse. Always replace with a
fuse of the same type and rating. The fuse
type and rating are shown on the rear of
the unit
just below the fuse receptacle.
Always disconnect the unit from the mains
supply before replacing this fuse.
The case of this unit does become warm
during normal operation. (It is used as a
heatsink for the internal linear voltage
regulators).
Four suitable fixing screws are provided
with the optional 19” rack mount ears.
These must be used in place of the four
front side panel screws normally fitted.
If 19” rack mounting this unit it is advisable
to leave a ventilated space above the unit.