User manual

P1 Audio Processor User Manual Page 45
If working from balanced stereo monitor outputs, then connect as
shown below;
During track laying or overdubbing you require to hear both the
already recorded tracks plus the new source which you are
recording. The P1 has an on-board monitor mixer to allow you to do
this.
The headphone
volume control sets the
overall monitor level
fed to the headphones
and the MON
SOURCE level control
allows you to set the
level of your new
source material within
the monitor mix.
Although it is possible to ‘bounce back’ the source material from
most recording devices as part of the main stereo output, the source
is often output with a small time delay. This can be very off-putting to
the performer so we recommend using the P1’s zero latency
monitoring system whenever possible. In this case remember to