User manual

Page 22 User manual P1 Audio Processor
Adjust the P1’s input gain until the red LIM LED just lights.
Now set your recording device to monitor the incoming test audio
signal level on its record meter. If your recording device has a
recommended input level setting for best audio performance, then
set this first according to their recommendation. If there is no
recommendation then we suggest you set it to its maximum setting.
Now adjust the output
gain on the P1 using a
flat blade screwdriver
until the desired
maximum recording
level is viewed on the
record meter of your
recording device. We
suggest you set a
maximum level of 1dB
below 0dBFS.
As long as you are using this recording set-up there should be no
further need to adjust either the record device input gain or the P1’s
output gain setting.
Why use such a strange test signal during set-up?