User manual

P1 Audio Processor User Manual Page 21
SETTING UP THE OUTPUT GAIN
The P1 limiter takes care that the maximum audio level through the
processing chain is carefully monitoring and controlled without
having to adjust any settings.
However you do have to adjust the output gain control so that the
maximum level from the P1 (after the limiter) matches the desired
maximum recording level.
There are two ways to do this; by using a test signal, or by trial and
error using any dynamic audio source.
By test signal
If you have access to the internet, and your have access to a PC
which can replay sound files, then go to our web site
www.safesoundaudio.com and download the recommended set-up
test signal which is available as a .wav file.
Set-up your normal recording chain as shown below, so that this test
signal can be replayed from your PC hard drive from one channel of
your sound card, through the P1’s line input and then entered back
into one channel of your recording device.