User manual

Page 16 User manual P1 Audio Processor
Detailed operational guide
POWER ON
With the IEC mains cord securely
fitted to the rear of the unit, plug
the P1 into a suitable mains
power source taking special care
to ensure the mains voltage is as
indicated on the rear panel. Note
that a UK 240V AC supply is
suitable for powering a unit
marked ‘230 VAC’
Check that the front panel green
PWR LED is lit.
If the PWR LED does not light then immediately disconnect the P1
unit from the mains supply and go to the fault finding section of this
user manual.