User manual

P1 Audio Processor User Manual Page 13
BALANCED LINE OUTPUT
Any standard ‘off the shelf’ balanced line level cable should be
suitable. If wiring your own, at the P1 end use a standard ¼” 3-pole
jack plug wired as follows;
It is also possible to feed this output to an unbalanced destination
which may be the case when feeding the P1’s line output to some
unbalanced PC sound card inputs. In this case use a standard ‘off
the shelf’ unbalanced line level cable. If wiring your own, at the P1
end use a standard ¼” 2-pole jack plug wired as follows;
It is possible that the input jack on some unbalanced sound cards will
be for a stereo input typically via a 3.5mm stereo jacket socket.
Assuming you are feeding only one P1 unit into this soundcard’s
stereo input then it is important to ground the unused input of the
soundcard to prevent crosstalk. A typical wiring scheme is shown
below.