Instruction manual

HOW TO INSTALL
7
FOR
BABY
AND
CHILD
USE
HOW TO INSTALL
Important: If using an Extension Strap, positioning the
Attachment Clip above the baby may lead to injury in an
accident therefore make sure that the Attachment Clip is
not positioned in front of the vehicle seat.
Attachment Clip must
not be in front of the
vehicle seat front.
Attachment Clip must
be behind the front of
the vehicle seat.
Front of
vehicle
Extension
Strap
Attachment
Clip
TO REMOVE RESTRAINT FROM VEHICLE
A.
B.
C.
Disengage seat belt tongue from buckle and remove from restraint.
Fully press Upper Anchorage Strap Adjuster Button (A)
while pulling Upper Anchorage Strap (B) to slacken as
shown right. In some vehicles loosening of the Upper
Anchorage Strap may be difficult. If so, try pushing the
restraint against the vehicle seat back or slightly lifting the
restraint to release the tension.
Disengage Attachment Clip from Anchor Fitting. The child
restraint is now disconnected.
Pull Adjustment Strap
to remove slack
Storage
Strap
Fully press Adjuster Button (A)
while pulling Upper Anchorage
Strap (B) to lengthen.
A
B
ANGULAR ADJUSTMENT OF RESTRAINT
Some vehicle seats have more rearward slope than
others. If the angle of the seat causes the baby to
be too upright for comfort, the angle may be
altered by placing a firm packing between the
seat and the underside of the base. Packing
can be a firmly rolled up towel or nappy.
Do not remove all of the rearward slope by
over packing. Always leave a rearward
slope angle of approximately 10 degrees.
10°