Instruction manual

5
FOR
BABY
AND
CHILD
USE
HOW TO INSTALL
If the car is fitted with child restraint anchorage point.
Locate the anchorage point behind the rear seating position
to be used. Consult the car owners handbook for the
location of the anchorage points.The anchorage point should
be directly behind and central to the restraint. Remove
thread plug from the parcel shelf, floor/roof, etc. and install
anchor bolt and fitting as shown right, ensuring correct
direction of anchor fitting as previously illustrated. The
spacers provided may need to be used for vehicles with
recessed anchorage points.
CAUTION: DO NOT OVERTIGHTEN THE ATTACHMENT BOLT
MAXIMUM TORQUE 20 N.m.
Anchor bolt
Lock washer
Anchor fitting
Spacers (if required)
Trim
Metal
panel
Securing nut
Lock washer
Anchor bolt
Anchor fitting
Spacers (if required)
Reinforcing washer
Trim
Metal
panel
Centre line of
seating position
200 mm
min.
Drill 9 mm
diameter hole.
Do not drill
through fuel
lines, fuel tanks,
electrical wiring
or radio speakers.
If the car is not fitted with
child restraint anchorage points.
For Sedans only - Drill 9mm diameter hole in
the parcel shelf on the centreline of the
seating position as shown right. Before
drilling the hole, check the underside for
accessibility.
Install the anchor bolt as shown below right
ensuring the correct direction as shown on
page 4. Make sure to use the reinforcing
washer and lock washer on the
underside of the panel.
For vehicles other than Sedans - In
Australia, consult your nearest child
restraint fitting station or traffic authority for
vehicle inspection to find the best, correct
position for the placement of the anchorage point, and for the correct attachment
bolt length and use of spacers. In New Zealand, consult the agent for the vehicle.
WARNING: Child restraints must not be attached to
unsound metal or to wood, or synthetic structures.
When drilling 9 mm hole do not drill through fuel lines, fuel
tanks, electrical wiring, or radio speakers. Webbing straps
must be protected from sharp corners and edges. The
anchor fitting must be used only as described above. It
must not be hooked onto any other object.
Note to Queensland purchasers: The installation of
anchorage points must be approved by authorised officers
appointed by Queensland Transport. Authorised officers
can be sourced from all Queensland Transport Customer
Service and Queensland Ambulance Service Centres.
Front of vehicle
Front of vehicle