Instruction manual

22
HOW TO USE
FOR
BABY
AND
CHILD
USE
?
Crotch 3-bar slides
HOW TO CLEAN
The restraint has a flame retardant cover which is removable for cleaning. Cleaning instructions
are on the care label attached to the cover. If fluffy cover is fitted then washing cover prior to use
will remove excess fluff. Ensure that the inside of the buckle is free of foreign matter. Cleaning
instructions for the buckle are on page 24. Use only mild soap
and water to clean all metal and plastic parts of the restraint.
Do not use chemicals or cleaning agent.
Remove the restraint from vehicle as instructed on page 7.
Disengage harness tongues from harness buckle.
For easier accessability to crotch 3-bar slides convert the
restraint to baby use mode as instructed on page 10 item
B. Tip the restraint on its back to access the underside of
the seating area.
From underneath the restraint feed Crotch 3-
bar slide through slots in the body and cover
by turning 3-bar slide and pushing through
slot in restraint and cover.
TO REMOVE COVER:
C.
A.
B.
D.
WARNING: Do not use the restraint with harness shoulder straps set at different heights or
fed through mis-matching slots. Ensure harness straps are not twisted and that all
straps are secure by pulling each harness strap.
E.
F.
Ensure there are no twists in the
harness strap and the buckle tongues
face the correct way.
Connect shoulder strap to metal strap
connector at rear of restraint.
Repeat for other shoulder strap. It is
better to change one strap at a time so
that the other strap will be a guide for
re-assembly. Return backing plate
ensuring it clips back into position.
G.
RETRACTOR HARNESS MODELS
FORWARD FACING MODE
Shoulder straps must
be threaded through
appropriate shoulder
strap slots, then
under the bar at rear
of restraint.
Ensure the shoulder strap is threaded through the slot, then
under the bar & connected to the strap connector.
Bar
Strap Connector
Retaining Slide
3-bar
Slide
Body
Cover
Thread straps as instructed below.