Instruction manual

HOW TO USE
FOR
CHILD
USE
19
?
F
O
R
W
A
R
D
F
A
C
I
N
G
PLACING CHILD IN THE RESTRAINT
- MANUAL HARNESS MODELS
B. Place child in the restraint and feed
each arm through shoulder straps. Pull
harness buckle up between child’s legs.
A. Lengthen harness by lifting Harness Adjuster
Lock up while pulling on either shoulder strap
until the harness will accomodate the child.
Harness
Lap Strap
Crotch Straps
Shoulder
Strap
Pull to remove slack
from Harness Lap Strap
C.
TO REMOVE CHILD
TO RECLINE RESTRAINT
Fit either harness tongue into the
harness buckle followed by the other
tongue until a click is heard. Should the
second tongue not insert press the red
button and reinsert the tongues.Ensure
secure engagement by pulling harness straps.
Press red button on harness buckle then both harness tongues will be released.
Lift the shoulder straps from the child’s shoulders.
The child restraint may be reclined or positioned upright without removing the child from the
restraint. You will be able to gain partial recline from upright position by just pushing the blue
recline latch up. The extent of the recline will be limited by the location of the anchorage point.
Loosening of the upper anchorage strap may be required when positioning the restraint to either
an upright or reclined position. Once the required position has been determined ensure to tighten
the upper anchorage strap.
D. Ensure slack is removed from harness lap strap by pulling shoulder
straps then pull harness adjustment strap to adjust harness to a
comfortable but firm fit. Check that slack in straps is minimal.
Shoulder Harness Straps must fit firmly to the child. A loose
harness could result in serious injury in an accident. Do not use
restraint if straps do not tighten and contact your local authorised
service agent for repair.
Click
Front of vehicle
Pull to
tighten
Lift & hold
Harness Adjuster
Lock up
(Under Flap)
Pull to
lengthen
B
.B
.