Instruction manual

18
FOR
CHILD
USE
F
O
R
W
A
R
D
F
A
C
I
N
G
HOW TO INSTALL
Anchor
fitting
Attachment
Clip & Cover
Ensure lap part of
seat belt is below
the Hooks.
Pull sash portion
of seat belt to
remove slack.
Lap seat belt
Front of vehicle
H.
J.
K.
Fully lengthen seat belt. Insert seat belt into child use
seat belt path as shown right, ensuring that the seat
belt is behind the harness straps and that the lap
part of the seat belt is below the hooks as
shown right.
If seat belt ‘lock-off’ is fitted, follow steps above,
through to point K. Press the seat belt ‘lock off
while threading the sash part of the seat belt
through the slot in the ‘lock off’, then release
the ‘lock off’ (refer to illustration below).
Push the restraint firmly
downwards, while pulling on
sash part of seat belt to
tighten the seat belt through
the ‘lock off’. This will prevent
the seat belt loosening.
I. Engage seat belt buckle and tongue, ensure
to remove all slack from lap part of seat belt
by pulling sash belt. Adjust the seat belt to
hold the restraint firmly against the vehicle
seat. For inertia/retractable seat belts, allow
excess belt to feed back into retractor.
Fit the attachment clip to the anchor
fitting as shown right. Make sure to
remove as many twists as possible
from the upper anchorage strap.
THIS TETHER STRAP MUST ALWAYS BE FITTED
WHEN THE CHILD RESTRAINT IS USED IN A VEHICLE.
Tighten Adjustable Upper Anchorage Strap by pulling adjustment strap to remove slack as
shown below, but do not over-tighten causing the restraint base to lift off the vehicle seat. Fold
up excess strap and use storage strap to neatly store excess strap away from child's reach.
SEAT BELT ‘LOCK OFF’ (WHERE FITTED)
A
B
Fully press & push Adjuster
Button (A) while pulling Upper
Anchorage Strap (B) to lengthen.
Note: Manual
harness model is illustrated.
Child use
seat
belt path
Upper Anchorage
Strap
Storage Strap
Upper Anchorage
Adjustment Strap
Anchor
Fitting
Seat
Belt
‘Lock
Off’
Attachment
Clip & Cover
Pull to
remove
slack
Press to engage
lock fully.