Instruction manual

17
FOR
CHILD
USE
F
O
R
W
A
R
D
F
A
C
I
N
G
INSTALLING INTO VEHICLE (FORWARD FACING)
HOW TO INSTALL
A. If the Stabilising Bar is extended, unhook
hook & loop attachments and push trim away
from restraint.
B. Press blue button on left side (facing
seat) and gently push stabilising bar all
the way into recessed area.
(UPRIGHT OR RECLINED)
G. Position restraint in forward facing mode
and align restraint centrally to the chosen
seating position as shown on page 18.
Some vehicle seat fabrics (particularly
velours) may be damaged by a child
restraint used continuously. We
recommend the need of a thick towel or
other protection to keep the vehicle seat
in good condition.
FULLY UPRIGHT
CHILD USE MODE
FULLY RECLINED
CHILD USE MODE
E. Determine whether an upright or reclined
position is preferred. If the fully reclined
position is preferred proceed to item G.
If you wish to use the fully upright
position or one of three intermediate
positions proceed to item F. The restraint
has 4 positions for child use.
F. Place one hand on the front corner of base
firmly, while with the other hand push the blue
recline latch up to unlock and push back until
the restraint is at the desired position. Ensure
the blue recline latch is engaged into position
by pushing on the restraint.
Do not recline into baby position when using
restraint in forward facing child use mode.
C. Re-attach hook & loop attachments on trim.
Convert the restraint to child use mode by
placing one hand over rear hump and lift the
top end of restraint with the other hand until
audible click is heard.
D.
WARNING: DO NOT USE RESTRAINT IN FORWARD- FACING POSITION WITH THE
STABILISING BAR PULLED OUT.
Push Stabilising Bar
Press Blue
Button
Push blue
recline
latch up
while
pushing
restraint
back.
Stabilising
Bar.
Hook & Loop
attachments