Instruction manual

14
FOR
BABY
USE
?
R
E
A
R
W
A
R
D
F
A
C
I
N
G
HOW TO USE
1.
2.
3.
4.
5.
6.
7.
Upper shoulder strap slots.
Medium shoulder strap slots.
Lower shoulder strap slots.
Shoulder harness straps.
Harness tongues & buckle.
Lap strap slots.
Crotch strap slots.
A.
B.
Pull Padded Insert forward
until straps are free from the
shoulder harness strap slots.
Adjust shoulder harness
straps height as instructed
below.
If you do not intend to use the Padded Insert, remove it while
adjusting harness. If using medium shoulder strap slots for a
baby less than 12 kg you can continue to use the Padded
Insert. If an older baby’s legs do not have enough room,
convert to child use mode.
DISCONNECTING HARNESS STRAPS:
- STEPS IN CHANGING SHOULDER STRAP SLOTS
C.
G.
A.
B.
D.
E.
F.
Remove the restraint from vehicle as instructed on page 7.
At the rear of the restraint, pull down backing plate (if fitted)
and remove one of the harness shoulder straps from metal
Strap Connector by slipping strap through open slot. The
metal Strap Connector is shown in diagram right.
Pull the shoulder strap through slot.
Insert shoulder strap through restraint
slot which will position shoulder strap
level with or above the child’s shoulder,
shown right. Ensure that the Shoulder
strap passes through matching slots in
cover and restraint body.
Ensure there are no twists in the
harness strap and the buckle tongues
face the correct way.
Connect shoulder strap to metal strap
connector at rear of restraint, as shown
above right.
Repeat for other shoulder strap. It is
better to change one strap at a time so
that the other strap will be a guide for
re-assembly. Return backing plate
ensuring it clips back in position.
WARNING: Do not use the restraint
with harness shoulder straps set at
different heights or fed through mis-
matching slots. Ensure harness straps
are not twisted and that all straps are
secure by pulling each harness strap.
RETRACTOR HARNESS MODELS
REARWARD FACING MODE
Shoulder straps must
be threaded through
appropriate shoulder
strap slots over the
top of bar at rear of
restraint.
Ensure the shoulder strap is threaded through the slot, then
over the top of the bar & connected to the strap connector.
Thread straps as instructed below.
Bar
Strap Connector
RETRACTOR HARNESS MODELS
REARWARD-FACING Shoulder Harness threaded OVER Bar.
The
Adjuster
Strap is
OVER
the Bar.
Harness Shoulder Straps
33
22
11
4444
55
66 66
77 77
Strap Connector