Instruction manual

12
?
FOR
BABY
USE
R
E
A
R
W
A
R
D
F
A
C
I
N
G
HOW TO USE
PLACING BABY INTO RESTRAINT
A.
B.
C.
The harness shoulder straps should
be in the lowest or medium position.
Refer to page 13 for correct
shoulder harness strap height.
The restraint can be used with or
without the Padded Insert.
Ensure Upper Anchorage
Strap is attached to Anchor
Fitting, then slacken Upper
Anchorage Strap and allow to
fall to the sides of the restraint
for easy access to the baby.
Slacken Harness Straps by pushing
Harness Adjuster up, grasping both
shoulder harness straps and pulling
out desired amount of slack. Release
Harness Adjuster lock when there is
enough slack and place harness to each
side of restraint.
C. Slacken Harness Straps by presssing the Blue Harness Adjustment Button, grasp both
shoulder harness straps and pulling out the desired amount of slack. Release harness
adjustment button when there is enough slack and place harness to each side of the restraint.
D. Lay baby on its back into restraint and fit harness as shown above. Make sure baby is dressed
to allow harness buckle to be pulled up between baby's legs e.g. a jump suit. Make sure
baby's arms and legs are free. Never wrap baby in a blanket before placing in restraint.
…or RETRACTOR HARNESS MODELS
Slackened Upper
Anchorage Strap
G. Pull harness adjustment strap to take up the slack in
the harness adjusting to a comfortable but firm fit.
Pull to remove slack
from Harness Lap Straps
Harness
Lap Straps
Crotch Straps
Shoulder
Straps
F. e slack from harness
lap straps by pulling shoulder
straps.
Remov
E. Fit either harness tongue into the harness buckle
followed by the other tongue until a click is heard.
Ensure secure
engagement by pulling harness straps.
Should the second tongue not insert, press the red
button and reinsert the tongues.
Click
Lift up
Adjuster
(under Flap)
Padded Insert,
if supplied, snugly
supports the baby
for extra comfort.
Harness
shoulder
straps
Front of vehicle
Note: Manual harness
model is illustrated.