Instruction manual

Hook and Loop
attachments
11
R
E
A
R
W
A
R
D
F
A
C
I
N
G
11
HOW TO INSTALL
I.
J.
Fit the attachment clip to the anchor fitting as shown
right. Make sure to remove as many twists as
possible from the upper anchorage strap.
Tighten adjustable upper anchorage strap by pulling adjustment strap to remove slack, but do
not over-tighten causing the restraint base to lift off the vehicle seat.
THIS TETHER STRAP MUST ALWAYS BE FITTED
WHEN THE CHILD RESTRAINT IS USED IN A VEHICLE.
Pull Adjustment Strap
to remove slack
Storage
Strap
A
B
Fully press Adjuster Button (A)
while pulling Upper Anchorage
Strap (B) to lengthen.
WARNING: DO NOT USE RESTRAINT IN REARWARD FACING MODE WITHOUT
STABILISING BAR FULLY EXTENDED.
Anchor
fitting
Attachment
Clip & Cover
Ensure Upper Anchorage
Strap is tightened, attached
to the Anchor Fitting and that
straps are the same length on
both sides of Attachment Clip.
Front of vehicle
Do not use this slot for
baby use installation
Feed seat belt between restraint
cover and restraint body.
(See previous page.)
A single twist
is required for
easy access to the
Upper Anchorage
Adjuster.
G.
H.
Re-attach hook and loop attachments and align
restraint centrally to the chosen seating position
as shown below.
Pull sash portion of seatbelt until all slack is
removed from Lap portion of seatbelt. Adjust seat
belt to hold the restraint firmly against the vehicle
seat back. For retractor seat belts, allow excess
belt to feed back into retractor.
Note: Seat belt buckle and tongue must not rest
between restraint cover and restraint. If the
seat belt buckle is adjustable, adjust the buckle
as low as possible away from the restraint.
FOR
BABY
USE