Instruction manual

FOR
BABY
USE
10
R
E
A
R
W
A
R
D
F
A
C
I
N
G
HOW TO INSTALL
CONVERT TO BABY USE MODE:
Once fully reclined, press the yellow latch
located under the restraint body while with
the other hand push the blue recline latch up
to unlock, continue pulling restraint forward
until fully reclined into baby use mode.
Position restraint rearward facing in the
chosen seating position.
Fully lengthen seat belt and feed the seat
belt between the restraint cover and the
restraint body through seat belt slots in
restraint.
D.
E.
FULLY RECLINE IN CHILD USE MODE:
Place one hand on the front corner of the base
firmly while with the other hand push the blue
recline latch up to unlock, continue pulling
restraint forward until fully reclined.
Unhook hook & loop attachments & gently
lift the cover, fully extend out stabilising bar
and gently push bar forward until a click is
heard. Stabilising Bar is now in place.
Note: Do not re-attach cover hook & loop
until you have installed seat belt.
C.
INSTALLING INTO VEHICLE (REARWARD FACING)
A.
B.
If Upper Anchorage Strap is folded up for
storage undo Storage Strap then lengthen as
illustrated right.
The restraint is normally packaged in the fully
upright child use mode so if you need to use
it for baby use you must first fully recline the
restraint, to convert the restraint to baby use mode as shown below.
Pull Adjustment Strap
to remove slack
Storage
Strap
Fully press Adjuster Button (A) while pulling
Upper Anchorage Strap (B) to lengthen.
A
B
Push bar
forward.
Click
Blue Recline Latch
Blue
Recline
Latch
Yellow
Latch
Yellow Latch
Pull out
Stabilising
Bar.