Product Manual

4100-37: 2 of 4: Rev. 4; 9/11

Insert Removable Dividers into 2-Slot Sorters: the hook at the lower front corner of the Divider fits into the open trough of the

front "W" loop on the Base; tilt the Divider up slightly, slide the Divider back, and lower the Divider until its back leg fits behind the

wire in the backmost loop of the Base.

Complete by inserting a Screw through the keyhole

into the threaded hole below the bottom stud of the Panel

Hanger, and tighten. Do both Panel Hangers.

Turn the Retaining Pin until the office panel is held snugly

between the Retaining Pin and the Panel Hanger; tighten the

Knob (finger-tight only!).

Assemble a Star Washer, a Retaining Pin, a

Flat Washer and a Knob to each Panel Hanger, as

shown.

DON'T USE BOTTOM WIRE!

Hang individual items where desired. Note: for proper

support, do not hang any individual items from the lowest

thin wire of the GridWall

Back Panel.

Slide the keyholes in the GridWall

Back Panel over the

studs on the Panel Hangers, then slide the Back Panel down

securely. (Note: the GridWall

Back Panel may be mounted

at one of three heights: top keyhole on bottom stud, or top

two keyholes on both studs, or bottom two keyholes on both

studs.)

Hang the Panel Hangers over the office panel, spacing them

apart to match the spacing between the keyholes in the

GridWall

Back Panel.