Installation Guide

Step 1 Step 2 Step 3
Step 4 Step 5 Step 6
The chair is ok now.
ATTENTION: MAKE SURE ALL SCREWS ARE
FULLY TIGHTENED BEFORE USING CHAIR
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents
list and hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly (included): Allen Wrench
Insert five Casters (7) into Star Base (6),
push hard until you feel or hear the
Caster(7) snap into place. Insert the LARGE
end of Cylinder Column (5) into the Star
Base (6) and carefully press downward with
moderate force until it is fully seated.
Connect the armrests(3) to seat(2)
by using six Medium Screws(9) and
six Washers(12).
Attach Control Mechanism (4) to Seat Assembly (2) with
the arrow towards the front of the chair, using four
Washers (12) and two Short Screws(8) and two Longer
Screws(11).
Now insert the small end of Cylinder
Column (5) into Control Mechanism
(4) and carefully press downward
with moderate force until it is fully
seated.
Assemble the Seat(2) to the Back(1) together,using
four Long Screws(10) and four Washers(12).
FULLY TIGHTEN ALL SCREWS USING ALLEN
WRENCH
PREPARATION