Setup guide

APC UPS Monitor
Supported Models
SAFARI Montage supports the following APC UPS USB Models:
APC Model
UPS
Type
UPS Cable Status
SmartUPS, SmartUPS VS (It has not been
confirmed that the cable
shipped with the VS is a
940-0095.), PowerStack 450, Matrix UPS,
ShareUPS Advanced Port
apcsmart
smart (note: using
Smart-Custom),
940-0024C
Supported
BackUPS CS USB, Pro USB, ES USB, RS/XS
1000, RS/XS 1500, and probably other USB
models
usb
usb (note: using
APC cables 940-
0127A/B/C)
Supported in
version
>=3.9.8
Before you begin:
• Ensure that the Customer is running SAFARI Montage 2.3.10 or higher.
• Ensure that the Customer’s UPS is an APC UPS USB device and is listed in the ‘Supported
Models’ table above.
• Ensure that the Customer has properly connected the USB cable from the APC UPS to the
SAFARI Montage server.
• Determine whether or not the Customer’s server requires a rebuild of the kernel:
o Kernel Rebuild Required: If a customer has an older, 30GB OS partition hard drive, they
will receive this message when they click on Admin>Tools>APC UPS Monitor. Proceed to
Step I: Rebuilding the Kernel.