Installation Manual

Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au
Page 6 of 8
11
Fasten the upper mounting
bracket (item 3) to the ‘A’ pillar
with self-taping screws (item 5),
refit the rubber wind lacing mould
(making sure it clips back into
position correctly).
12
Carefully install the snorkel body
(Item 1) to the guard panel, align
the snorkel body to the guard
panel and upper mounting
bracket.
When correctly aligned, fasten
the snorkel body to the guard
panel with body washers (Item 8)
and nyloc nuts (Item 9).
Fasten the snorkel body to the
upper mounting bracket with hex
bolts (Item 4).
13
Remove and discard the foam
strip from the air cleaner housing
inlet, remove any sticky residue
with a suitable solvent, trial fit the
connecting duct (item 12) to air
cleaner housing inlet
(if necessary grind or sand the
internal surface of the connecting
duct to achieve a slip on fit).
Apply Loctite 243 to the 5.0mm
mounting studs (item 13) and
install the studs finger tight into
the connecting duct (Item 12)
mounting inserts as shown.