Installation Manual

Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au
Page 4 of 8
5
Apply Loctite 243 to each of the
stainless steel mounting studs
(Item 7) and install the studs
finger tight into the snorkel body
(Item 1) mounting inserts as
shown.
NEW ZEALAND INSTALLATIONS ONLY :
Safari have developed 2 methods of Snorkel A pillar attachment, for the conventional method
please proceed with the current document alternatively please see the link below for further
instructions.
www.safari4x4.co.nz/apillarmounting
6
Carefully install the snorkel body
(Item 1) to the guard panel.
With the snorkel body correctly
positioned on the vehicle,
position the upper mounting
bracket (Item 3) and mark where
the plastic windscreen moulding
requires to be trimmed.
Remove the snorkel body.
7
Use a sharp knife to trim the
plastic windscreen moulding,
allowing approximately 3mm
extra at either end for clearance
to the upper mounting bracket.
Re-position the rubber ,A,pillar
wind lacing moulding and mark
where it requires trimming, only
trim away the section which locks
it into the plastic windscreen
mould.