Manual

Matchmaster Reassembly
(with full-length guide rod system)
Turn slide upside down. Flip barrel link toward the
muzzle and ease barrel into the slide until it seats on
the locking lugs in
the top of the slide.
Flip barrel link to the rear.
Insert the full-length guide rod, mak-
ing sure that the “ears” on the guide rod
are properly seated against the barrel.
Flip barrel link to up-right position.
Align the grooves in the receiver with
the lugs on the slide and press them
together until the barrel link
hole is visible through the hole
for the slide stop. Insert the
NOTE: Do not try to align the barrel
link, the disassembly notch and the top
stop all at the same time.
ink first. insert the slide stop
it alignsw
‘sh on your
shaft, and then rotate the slide stop upward until
disassembly notch. Be careful not to mar
the fini
The slide will move
_
Move the slide forward until
with the muzzle. Thread the recoil
spring onto the full-length
1 easily for alignment.
it lines up
\C(
guide-rod. Place the recoil
\
nvTwf spring cap on the
\[lN I
_\\ I
I \I\
\ -/\ I
.‘A I spring.
II II \
f/R i--SF