Manual

NOTE: Do not try to align the bar-
rel link, the disassembly notch and
the top of the slide stop all at the
same time. Align the link first,
insert the slide stop shaft, and then
rotate the slide stop upward until it
aligns with the disassembly notch.
Move slide to the rear until the
semicircular protrusion on the
back of the slide stop aligns with
the semi-circular disassembly
notch on the bottom of the slide.
Exercise caution as you rotate the
slide stop upward, or you will mar
the finish.
Push inward on the slide stop until
it snaps into place.
Push the slide a little further to the
rear and move the slide stop into
the slide stop notch.
Pull out the takedown tool or pin
and ease the slide into battery,
Lower the hammer.
The pistol is now ready to have a
magazine inserted.