Manual

Matchmaster Reassembly
(with “Captive” recoil-spring guide system)
Turn slide upside down. Flip barrel link toward the
muzzle and ease barrel into the
slide until it seats on the locking
lugs in the top of the slide.
Press barrel bushing into
and twist it clockwise to
Flip barrel link to the rear.
place
lock.
Insert recoil spring assembly into
place from the back of the slide.
Note: because the spring is held
under tension by the
takedown
tool or pin, you do not need to
adjust its position relative to the
slide and barrel; just make sure
that the “ears” on the guide rod
are properly seated against the
barrel, and the spring cap is at
least partially within the lower
portion of the slide.
Flip barrel link to upright posi-
tion.
Align the grooves in the receiver
with the rails on the slide and
press them together until the
barrel link hole is visible through
the hole for the slide stop. Insert
the slide stop.