Manual

© SAF Tehnika JSC
Ver. 1.10, 2012
CFIP Lumina series
Microwave Radio Systems
III CFIP Lumina FODU technical specification
Frequency range (GHz)
6 7 11 13 15 18 23 24 38
Channel Bandwidths (MHz)
4
20, 30, 40, 50, 56
Modulation 4QAM / 16QAM / 32QAM / 64QAM / 128QAM / 256QAM
Capacity (Mbps) 34 – 366
III Performance
Configuration
1+0,
Ring/Mesh (with RSTP),
2+0 (built-in Ethernet aggregation), 1+1 (Hot Stand-By)
Frequency stability (ppm) +/- 7
Traffic Interfaces 1 or 2 Gigabit Ethernet (electrical or optical)
III Ports
Flange
N-
Type
UBR
84
UBR
100
UBR
140
UBR
140
UBR
220
UBR
220
Circular
10mm
UBR
320
Ethernet
Optical 1 or 2 ODC ports
Electrical 1 or 2 RJ-45
Hybrid 1 ODC and 1 RJ-45
DC power connector 2-pin waterproof circular
RSL port, RSSI, BNC connector Output voltage vs RSL: 0 to 1.4V vs -90 to -20dBm
Serial port for configuration RS-232, Twin BNC connector
III Management features
Management port Ethernet VLAN or Separate Ethernet (RJ-45 or ODC)
SNMP Yes, SNMP traps, MIB, SNMP v1/v2c
EMS Web based, HTTP
ATPC feature Yes
ACM feature Hitless 0ms
Loopbacks Yes, modem, IF loopback
III Ethernet
Switch type Managed Gigabit Ethernet Layer 2
Max frame size 9728 bytes
MAC table 4K entries; automatic learning and aging
Packet buffer 128KB; non-blocking store&forward
Flow Control 802.3x
VLAN support 802.1Q (up to 4K VLAN entries)
QinQ (Double Tagging) Yes
QoS
64 level DiffServ (DSCP) or 8 level 802.1p mapped in 4
prioritization queues with VLAN support
QoS queuing Fixed or weighted (configurable ratio)
Spanning Tree Protocol 802.1D-2004 RSTP, 802.1Q-2005 MSTP
III Mechanical & Electrical
Temperature Range -27.4°F to 131°F
Dimensions: HxWxD, inches 11.2x11.2x3.1
Weight, lbs 8.5
Built-in DC port surge protection Conforms to ETSI EN 301 489-1; EN 61000-4-5; IEC 61000-4-5
Input DC voltage
-40.5V to -57V DC (conforms to ETSI EN 300 132-2)
Max. power consumption SP: 25-40 W; HP: 29-52 W