Technical Specifications

Saf-T Vent

EZ Seal

SINGLE WALL AL 29-4C

SPECIAL GAS VENT

2 Ft. Length — Install vent with a continuous pitch of 1/4” per foot, sloping upward toward the termination, draining back

toward the appliance or inline drain. It is important to provide adequate support to a Saf-T Vent EZ Seal system. Support

horizontal portions of the vent system at 6-foot intervals. Vertical sections should be supported at least every 30-feet and after

every offset or transition.

Straight Lengths:

Part Number DIM - A DIM - B DIM - C

Nominal Diameter Installed Length Maximum OD

9305 3 22.5 3.4

9405 4 22.5 4.4

9505 5 22.5 5.4

9605 6 22.5 6.4

9705 7 22.5 7.4

9805 8 22.5 8.4

9905 9 22.5 9.4

91005 10 22.5 10.4

91205 12 22.5 12.4

91405 14 22.5 14.4

91605 16 22.5 16.4

3 Ft. Length — Install vent with a continuous pitch of 1/4” per foot, sloping upward toward the termination, draining back

toward the appliance or inline drain. It is important to provide adequate support to a Saf-T Vent EZ Seal system. Support

horizontal portions of the vent system at 6-foot intervals. Vertical sections should be supported at least every 30-feet and after

every offset or transition.

Part Number DIM - A DIM - B DIM - C

Nominal Diameter Installed Length Maximum OD

9307 3 34.5 3.4

9407 4 34.5 4.4

9507 5 34.5 5.4

9607 6 34.5 6.4

9707 7 34.5 7.4

9807 8 34.5 8.4

9907 9 34.5 9.4

91007 10 34.5 10.4

91207 12 34.5 12.4

91407 14 34.5 14.4

91607 16 34.5 16.4