Manualshelf

Specifications

ManualsBrandsSaeco ManualsCoffee MakersOdea Go
21222324252627282930
Page 13 / 13 Rev. 3 / Jan. 2009 Saeco International Group
03 OPERATING TALEA / ODEA - LINE
DISPLAY MESSAGE SHOWN INSTRUCTIONS FOR TROUBLESHOOTING
Turn machine off and on to solve the problem Turn the appliance off and then back on after 30
seconds to resolve the fault.
Call Service Centre The problem requires the intervention of the Service
Centre
Insert drip tray Insert the drip tray
Close coffee bean hopper lid The coffee bean hopper lid must be closed to
produce beverages.
Insert ground coffee This message is shown if the user selected the use of
this type of coffee when the products were specifi cally
programmed.
Insert brewing unit Insert the brewing unit in its intended location
Insert dreg drawer Insert the dreg drawer
Empty dreg drawer Remove the dreg drawer and empty.
NOTE: the dreg drawer must only be emptied when
the appliance is switched on. The drawer must
be removed for at least 5 seconds. If the drawer
is emptied when the appliance is switched off the
message is not reset.
Close side door Close the service door.
Fill water tank Fill the water tank
Empty residual water tray Empty residual water tray
Prime circuit Start the automatic water cycle fi lling The appliance
makes 5 attempts to fi ll the cycle automatically.
If these attempts fail, the Service Centre must be
informed about these ventilation attempts.
The descaling cycle did not run correctly. Repeat the operation as described in the appropriate
chapter in the instruction booklet
Replace Aqua Prima fi lter This message is only displayed if the fi lter control is
enabled (see notes in the instruction booklet)
The fi lter should be replaced in the following cases:
1) Over 60 litres of water have been dispensed for
drinks
2) 90 days have elapsed since installation
3) 20 days have elapsed since the coffee maker was
last used.
The cleaning cycle did not run correctly Repeat the operation as described in the relevant
chapter in the instruction booklet.
Descale appliance Carry out the descaling cycle
Standby Press the “ON” key
3.3 Messages - troubleshooting