Instruction Manual

BC-AMP05 Amp mounting bracket

Fairing Disassembly

During this installation it is highly

recommended to take pictures throughout

the disassembly process. Take notice also

how the factory wiring is routed throughout

the fairing. This will have to be duplicated

in reassembly

1. The removal of the fairing doesn’t

require the removal of the

windshield or headlight assembly.

2. Remove (6) T25 Torx screws from

the inner fairing. (Figure A)

3. Remove (4) ½” nuts holding the turn

signal and running light assemblies

to the lower fairing mount.

(Figure B)

4. Unplug the turn signal assembly,

then remove the outer fairing. From

the front of the fairing lift up,

releasing the headlight bracket from

the headlight assembly. (Figure C)

5. Unplug the headlight assembly and

set outer fairing aside. (Figure D)

(Figure A)

(Figure B)

(Figure C)

(Figure D)

PAGE 1
BC-AMP05 Amp mounting bracket During this installation it is highly recommended to take pictures throughout the disassembly process. Take notice also how the factory wiring is routed throughout the fairing. This will have to be duplicated in reassembly Fairing Disassembly 1. 2. 3. 4. 5. The removal of the fairing doesn’t require the removal of the windshield or headlight assembly. Remove (6) T25 Torx screws from the inner fairing.
PAGE 2
BC-AMP05 Amp mounting bracket 1. Remove (2) ½” nuts securing the radio and inner fairing to the bikes frame. Tilt radio bracket toward the back of bike and remove the bracket and radio assembly. (Figure D) 2. Place BC-AMP05 bracket on Brake or Clutch side of the Motorcycle. • 3. 4. For proper clearance, ensure that the bracket is mounted as shown in (Figure E) and (Figure F). (Figure E) Tighten down bracket with factory ½” nut. Reinstall fairing in reverse order of removal on page 1.