Operation Manual

Installation
32
6/7<-> 7/8 <-> 8/9 <->1/4 <-> 1/3 <-> 2/5 <->
3/5 <-> 9/10.
 Mode: Select the mode with DVB-S or
DVB-S2.
Press [ok] button.
3. Press [yellow] button to edit the select transponder.
4. Press [blue] button to delete the select
transponders.
5. Press [INFO] button to display the search channels
of the transponder.
8.1.6 Search Channels (Motor Antenna)
You can set the position of the satellites when using a
motor antenna for efficient channel search.
1. Check that your antenna connection and the
selected antenna type are correct.
2. Select the satellites that the motor antenna is
pointing to.
3. Set the type and location of your motor. (Motor
Setting)
4. Set your antenna position for the selected satellites.
5. Set the operation limit of your motor.
6. Press [red] button to scan, the found channels will
be listed.
7. When the search has completed, select save and
press [ok] button to save and exit.
Note:
1. Only channels of one satellite can be searched when
using a motor antenna. Please repeat the search
process to search more satellites.
2. Press [EXIT] button to stop and press [ok] button to
save and exit.
3. Refer to Setting Transponder for details in
transponder setting.
8.1.7 Motor setting
Set the type and location of your motor.
1. In Menu/Install/Satellite/Edit Satellite menu,
press [yellow] button.
2. Select motor type at motor item.
 DiSEqC 1.2: General motor antenna using
DiSEqC 1.2.
 USALS: Motor antenna using USALS.
3. Select My Longitude and enter the longitude and
direction.
4. Select My Latitude and enter the latitude and
direction.
5. Select Set Limit and set the limit for the Motor.
 Select the value is east or west
 Select the Move Step or Move Continue to
move the Motor to east or west.
 Select the save and press [ok] button to save it.
Note: When Motor Type is set as DiSEqC 1.2, the menu is
not My Longitude, My Latitude.
You created this PDF from an application that is not licensed to print to novaPDF printer (http://www.novapdf.com)