Operation Manual

Basic Operations

enhance your viewing enjoyment.

4.3.3 Connecting the Network

1. Connecting to the LAN:

Connect one end of the Ethernet cable to the product and the other end to the LAN router.

2. Connecting to the Wi-Fi (Wireless LAN):

You can connect the network via the Wi-Fi access point or DSL/cable modem.

a. Plug in the wireless USB dongle to the USB port.(Separate purchase required)

b. Set the options for the Wi-Fi.

 Network Name (SSID): Select the network name of your Wi-Fi access point from the list.

 Security Type (WEP): This product supports WEP 40/128bit ASCII and WEP 40/128bit HEX. The security

type of the Wi-Fi and the product shall be set the same.

 Password: When using the security type, you must set the password. Enter the same password in the

Wi-Fi setting menu.

3. Connecting to the 3G:

Connect the network via the 3G card. Plug in the USB that has 3G card.

Note:

1. Make sure the distance between the Wi-Fi access point and the product is not too far away. This may

lower the quality of service.

2. It is recommended to purchase a wireless USB dongle distributed by RT73, RT8192cu, RT3070, RT2870,

RT2070, RT8712u, ZD1211b, ZD1211. Other products may not function or respond.

3. We recommend the network connection over a direct LAN.

You created this PDF from an application that is not licensed to print to novaPDF printer (http://www.novapdf.com)