Operation Manual

English
20
Note:
When you choose LNB type “Universal”, you
cannot modify 22K.
10.1.1.4 0/12V (Optional)
You can use [/] key to switch “0V / 12V”.
When this item switches to “12V”, receiver
will receive TV and radio input signal from
12V port. If the item switches to “0V”, the
receiver will receive all signals from 0V port.
10.1.1.5 Power
In “Polarity” item, [/] key to switch or
press [ENTER] key to enter list for selection
among "OFF" , "13", "18", "13/18", "13.5",
"18.5" and "13.5/18.5".
10.1.1.6 Motor
Motor: In “motor” item, you can press [/]
key to switch “OFF/ DiSEqC 1.2 / USALS”
Functions.
In “Satellite” item, press [/] key to switch
satellite that you want to scan or press
[ENTER] key to enter satellite list for
selection.
10.1.2 Edit TP
When you enter to “Transponder” menu,
there will display the screen like below:
1. In “Transponder” menu, you not only can
use [/] key to select transponder but also
can use [Add] and [Delete] functions.
 When you press [GREEN] key, it will
display “New TP” in “Transponder”
menu; You should set the parameters of
“Frequency” and “Symbol Rate” for this
new transponder. The parameters of “TP
Frequency” and “Symbol Rate” can set
by number keys. The available range are
“3000~13450 MHz” and
“1000~45000Ks/s”.
 When you press [yellow] key, it will
display Edit TP menu,you could rejigger
the parameters of TP
 When you press [blue] key, there will
show up a warning message for
reminding whether you will delete the
current transponder or not. If you select
“Yes”, the current transponder will be
deleted, and the total account of
transponder will reduce 1
correspondingly.
2. For the existed transponder, you also
can use number keys to modify the
parameters of “TP Frequency” and “Symbol
Rate”.
3. When you complete your modification,
Press [RED] key, it will show up a dialog to
ask you scan mode, program type, scan type