Operation Manual

NVR User Manual

Parameter

Description

DNS Server

UPNP

You can use the UPnP function to enable the fast connection of the

device to the WAN via a router without port mapping.

Note:

If you want to enable the UPnP function of the NVR, you must

enable the UPnP function of the router to which your NVR is

connected.

How to configure the IP Address, Subnet Mask, Gateway, Primary DNS Server,

Secondary DNS Server, please refer to “ Appendix II Common operations > 2. Configure

the IP Parameters”.

Step3 Click Save button to take effect.

-------End

The system can be configured to send an email to the designated users if an alarm or

motion event is detected etc..

Before you configure the Email settings, the NVR must be connected to a local area

network (LAN) that maintains an SMTP mail server. The network must also be connected

to either an intranet or the Internet depending on the location of the e-mail accounts to

which you want to send notification.

Step1 Choose ” (Parameter Configuration) > Local settings > Email”. The Email page is

displayed.