Operation Manual

NVR User Manual

Step6 Click Save button to take effect.

-------End

【Motion Detection】

Follow the steps to set the motion detection parameters. In the live view mode, once a

motion detection event takes place, the NVR can analyze it and perform many actions to

handle it. Enable motion detection function can trigger certain channels to start recording,

or trigger full screen monitoring, output alarm, send Email, upload figure to FTP, buzzer

alarm and so on.

In the live view mode, there are icons at the right bottom of the screen for each channel.

 The Icon indicate alarm was triggered.

 The Icon indicate the IPC is recording.

In this chapter, you can follow the steps to schedule a record which triggered by the

detected motion.

Choose ”Menu > Settings > Alarm Settings > Motion Detection” in the Menu interface. The

Motion Detection interface is displayed.

Step1 Select channel from drop-down box list.

Step2 Check the checkbox to enable motion detection function.

Step3 Check the checkbox to select the linkage method. You may refer to follow table for details of

linkage methods.