Operation Manual

User manual
8
7. Basic Operations
7.1 Turn on STB
Firstly, press the Device’s Main Power to turn on
the unit.
If the STB is used for the first time, it will play the
first channel from the default Channel List.
Otherwise, it will play the last channel before
being turned off.
Frequently Asked Question
Q: The power of my STB has been turned on
and not in Standby mode, but the TV screen
showed nothing:
A: Make sure the TV set has been set to the
correct video input (not the TV channels). For
example, if you have connected the unit with the
Video1 input of the TV set, the TV set has to be
switched to Video1.
Q: The power of my STB has been turned on
and not in Standby mode, but the TV screen
showed nothing except “No Signal”
message.
A: This means the channel you select has no
signal. There could be several causes:
1 The channel which you select is not in your
allocated satellite. The solution is to change the
channel.
2 The signal of current TV channel is too weak.
Try to switch to other strong signal
channels. If the problems still exist, please
consult your local dealer or other professionals
for technical service.
3 You have used the Dual LNB, and need Modify
LNB Type
7.2 Standby Mode
1 Pressing Key Power [
] can enter the
Standby
mode.
2 In Standby mode, pressing Key Power again
can move back to the unit and go on playing the
previous channel.
3 Users can also disconnect the device’s main
power to end the Standby mode.
7.3 Next / Previous Channel
In full screen, press keys [▲,▼] to change
channel.
7.4 Volume
In full screen, press keys [◄,►] to adjust
volume.
7.5 Number Keys
In full screen, use number keys and press OK on
the Remote Control Unit to change channels.
7.6 Mute
1 Press key [
] to mute the sound and the
screen will show up.
2 Press key Mute again to restore sound.
7.7 Pause
1 In playing mode, press key Pause [ II ] , and
the
picture will pause, but the sound of the channel
will still remain.
2 Press key Pause again, and the screen’s
picture will skip over to the current playing
picture, and the sound of the channel will
correspondingly play.
7.8 Recall
Press key Recall [
] will directly switch to the
previous
channel that you watch before current channel.
7.9 FAV
1 In full screen, press key [FAV] , and it will
display a window of “Favorite Group on the left of
the screen like below.
2 In the window of “Favorite Group”, you can
move highlight by pressing keys [▲,▼] then
press OK key to set favorite channel you choose.
3 Keys [◄,►/▲,▼] can implement the
“Page up/Page down” function.
4 The favorite group is the favorite channels you
have marked in Menu “TV channel list”. Please
refer to Favorite.