Operation Manual

User manual
6
(GREEN KEY)
Multi channels display. You can choice the desire channel use <,> ^,v and press ok confirm.
TELETEXT(BLUE KEY)
Shows teletext information of the current channel supports.
(FIND)
Use to prompt find channels sort by character.
4. Front panel
POWER: To switch the receiver power on/stand by
VOL^, v KEY: To adjust volume level, or to move cursor left or right in the menu
CH ^, v KEY : To change channels, or to move cursor up or down in the menu
Power Led: Lights up while the receiver is power on
Signal Led: When receiving signal is strong, the signal led is lighted.
Remote Sensor: Detects infrared signal from remote control unit
Display(4-Digit/7-Segment): Indicates operating status of receiver
MENU KEY: To enter into the main menu.
OK KEY: To see TV/Radio channel list, or to confirm in the menu.
Card Slot: (Optional) depending on version, one or two Smart Card Interface for CONAX cards.
Insert the Smart Card chip side up!
5. Rear Panel
Please refer to the diagram above for all possible connections of your receiver
Do not connect the unit to the mains socket until all other connections have been made and checked.
LOOP: This enables the connection of another receiver.
13/18V 500mA MAX LNB IN: This port is to connect the coaxial cable from LNB of your Dish.
ANT IN(Optional): Connect to Analog TV antenna.
TV OUT(Optional) : This is used to connect your TV through RF cable.
VIDEO : This RCA connector is used to connect any external video.
0-12V :This is used to Connect 12V to an external 0V/12V switch.
AUDIO R/L : These RCA connectors are used to connect any external audio amp or system.
RS 232C SERIAL PORT: This is used to connect your receiver to a computer through a serial cable.
TV : This is used to connect your TV through SCART cable.