Operation Manual

User manual
16
3 For the existed transponder, you also can
use number keys to modify the parameters
of “TP Frequency” and “Symbol Rate” or
press [◄,►] key to switch it directly.
4 “Polarity” means you want to scan this TP
in horizontal mode or in vertical mode. You
can press [◄,►] key to select different
mode.
5 You can press [RED] button for TP scan.
It will show up a dialog to ask you Scan
mode, Program type, Scan type and NIT
Search on/off. After you set up, press [OK]
key to start scanning.
6 In the “TP Scan” item, press [Exit] key to
exit the scanning and save the current
parameters.
9.10 Single Search
1 You can press [RED] button for TP scan on
the Installation menu. It will show up a
dialog to ask you scan mode, program type
and NIT Search on/off.
2 Press [◄,►] key to select Scan type mode.
Manual means preset scan, that is
searching the existed TP. Blind scan
means, It is no need existed TP info.After
you set up, press [OK] key to start
scanning.
9.11 Multi Scan
1 You can press [GREEN] button for Multi
scan on the Installation menu. Multi Scan
can support search the multi satellite one
by one as user select.
2 Press [◄,►] key to select search mode.
Quick means preset scan, that is searching
the existed TP. Detail means blind scan. It
is no need existed TP info.
3 Press [OK] key, it will show up a dialog to
ask you scan mode, program type and NIT
Search on/off. After you set up, press [OK]
key to start scanning.
Auto DiSEqC
Press [Blue] key to run Auto DiSEqC function,
it can find the satellite connect to which port
automatically.
9.12 CA Setting
We provide one CA slots for user to use.
Receiver has build in smart card module with
CONAX system. By using cards in this system
provided by operators, it is possible to watch
many scrambled channels coded in this system.
This menu shows detailed information about
cord inserted into cord reader module. It allows
inserted according to help messages visible on
the bottom of the screen.
Note: