Operation Manual

User manual
15
Positioner: In “Positioner” item, you can press
[◄,►] key to switch “None / DiSEqC 1.2 /
USALS” functions.
9.6 22k
You can use [◄,►] key to switch “ON / Off”.
When this item is switched to “ON”, receiver will
receive TV and radio input signal from 22K port.
If the item is switched to “Off”, the receiver will
receive all signal from 0K port.
! Notice
When you choose LNB type “Universal”, you
can not modify 22K.
9.7 0/12V
You can use[Volume [◄,►] key to switch “0V /
12V”. When this item switches to “12V”, receiver
will receive TV and radio input signal from 12V
port. If the item switches to “0V”, the receiver will
receive all signals from 0V
9.8 Polarity
In “Polarity” item, [◄,►] key to switch “Auto / H
/ V” functions.
9.9 TP Edit
When you enter to “TP Edit” menu, there will
display the screen like below:
1 In “Satellite” item, press [◄,►] key to switch
satellite that you want to scan or
press[OK]key to enter satellite list for
selection.
2 In “TP Index” item, you not only can use
[◄,►] key to select transponder but also can
use[Add]and[Delete]functions.
 When you press[GREEN] key, it will display
“New TP” in “TP Index” item; You should
set the parameters of “TP Frequency” and
“Symbol Rate” for this new transponder.
The parameters of “TP Frequency” and
“Symbol Rate” can set by number keys.
The available range are “3000~13450
MHz” and “1000~45000Ks/s”.
 When you press[YELLOW] key, there will
show up a warning message for reminding
whether you will delete the current
transponder or not. If you select “Yes”, the
current transponder will be deleted, and the
total account of transponder will reduce 1
correspondingly.