Operation Manual

CANOPY
The Goblin Urukay canopy has a very effective locking system in order to eliminate vibrations and
optimize aerodynamics.
You must install the following to complete the canopy assembly:
· Canopy grommets (Fig 6), Canopy edge protection (Fig 7).
The canopy hole must be 12 to 12.5 mm in diameter. Initially is 9 mm. You can enlarge the hole
slightly to optimize the vertical position of the canopy itself.
To install the canopy:
· Insert the canopy from the front up to the area of the block shown in Fig. 8
· Join the edges.
· Insert the H0036 knobs (Fig.9)
Allows for quick installation and removal of the canopy.
The canopy hole must be 12 to 12.5 mm in diameter.
You can enlarge the hole slightly to optimize the vertical position of the
canopy itself.
Always ensure the proper installation and locking before each flight. The lock
button must always come out to ensure locking.
It is recommended to attempt removal by forcing the canopy slightly to
ensure proper locking.
TAIL BELT TENSION
*Check the proper assembly of the tail boom.
*Check that the aluminum part of the tube is against the M3 stop screw.
*Loosen the tail group by loosening the 4 M3 screws.
*Install the belt onto the pulley, taking care to respect the direction of rotation (figure 1 ).
*Rotate the tail drive several times by hand.
*Load the spring by a rotation of 270° the tensioning arm ( clockwise )
*Tension the boom until the tensioning arm is aligned with the frame.
*Tighten the 4 screws.
*Check that the tail output shaft is perpendicular to the tube. (figure 2 )
*In figure 3,4, 5 you can see the three conditions, ok, too loose and too tight.
NOTE . To disassemble the tail boom it is possible to remove the pulley H0101-S without loosening the tail unit.
Remove the locking screw and pull down.
Box 2
Page 30
Chapter 13, Installation Of The Boom, Canopy