Operation Manual

Flat Head Cap Screw M3x8mm

Set Screw

M3x20mm

(HC150-S)

Red/White Tail Boom (H0440-S)

Blue/White Tail Boom (H0443-S)

Locking Element

Tail Assembly

(H0041-S)

Locking Element Tail Assembly .... X 2

Boom Spacer

(H0082-S)

Set Screw M3x20mm

......x1

Note:

Metric Hex Nylon Nut M3

(HC206-S)

DETAIL A

DETAIL B

Tail Boom Assembly

Locking Element Tail

(H0041-S)

Attaching H0082-S to the boom:

Pre-assemble the two boom spacers H0082-S with the M3x20 socket set screw.

Insert into the boom tube completely done up.

Center the holes, then unscrew until there is contact with the walls

Lock everything with the adhesive.

Assemble H0040-S in the boom:

Before assembling the two parts in the boom we suggest tightening the

M2.5 screws into the two plastic parts to pre-thread them. In this way

when you will assemble the tail servo it will be easier to tighten the screws

into the plastic parts. Check the tail servo can fit, if necessary carefully sand

the hole.

Double

Sided Tape

Boom Spacer

(H0082-S)

Block Nut

(H0358-S)

Flat Head Cap Screw M3x8mm

(HC134-S)

Double

Sided Tape

Bag 13

Page 26

Chapter 12, Tail